Requirements For Solid-sealed Pole Mold
The mold is very important for the quality of Embedded Pole produced by APG process, especially the appearance quality. The mold suitable for epoxy resin APG process requires good sealing of the mold cavity, high finish of the mold cavity, easy demoulding, the feed port is at the lower side of the mold, and there is an exhaust groove on the upper part of the mold. The installation sequence of the mold is generally lower core pulling, static mold, dynamic mold, upper core pulling. Mold installation inspection: pay attention to the dynamic and static mold positioning pins and the lower core pulling positioning pin to ensure that they are located in the center of the positioning hole. Close the dynamic and static molds and the upper and lower core pulling and pressurize to the mold pressure holding state, use a feeler gauge to check the mold joint seam to ensure that the joint seam gap is ≦0.05mm.